Russell Truck Ltd.
::
Frame Forks/Fork Adapters
Frame Forks/Fork Adapters
Products
Axle Forks
Specially designed for lifting the Hendrickson Airtek/Steertek front axle is the hollow beam lifting fork. Special care must be taken when lifting the air suspension hollow beam front axles currently being used on many of the Volvo VNT and Freightliner Century Tractors making this fork or a front tire lift a must. Sold in pairs.
Our price: CA$390.00
Chain Hook Adapters
Hook adapters are designed to fit into the cast offset low profile fork adapters. They are used when lifting a load and chains are needed. For convenience they may be slid back and forth on the crossbar to avoid any obstacles that might be hanging from or bolted to the vehicle’s frame. Sold as pair.
Our price: CA$690.00
Fork Adapter 3"
Adapters are designed specifically to fit a 3" x 3" crossbar such as the FI wheel lift. As with all the forks, they are cast from a steel alloy which makes them stronger and lighter. On the back side they have been tapped to accept the Thandle which is used to secure the adapter to the crossbar. Sold individually.
Our price: CA$270.00
Fork Adapters 3.5"
Adapters are designed specifically to fit a 3.5" x 3.5" crossbar such as the FI wheel lift. As with all the forks, they are cast from a steel alloy which makes them stronger and lighter. On the back side they have been tapped to accept the Thandle which is used to secure the adapter to the crossbar. Sold individually.
Our price: CA$302.00
Fork Reducers
This attachment was designed to be used when the front axle you are picking up is narrower than the throat of the fork you are using. Simply slide the adapter over one ear of the fork and you have created 1" narrower opening in your fork without having to carry extra attachments in your tow vehicle. Remember to always use safety chains. Sold in pairs.
Our price: CA$150.00
Medium Fork 3"
Medium forks can be used for lifting from the frame, springs, or axle. They are also made out of cast alloy material, and are very light weight. They have a standard 2" mounting shaft, and raise the height of the lifting point 4-1/2" off the crossbar of your wrecker. Sold individually.
Our price: CA$139.78
Medium Fork 4.5"
Medium forks can be used for lifting from the frame, springs, or axle. They are also made out of cast alloy material, and are very light weight. They have a standard 2" mounting shaft, and raise the height of the lifting point 4-1/2" off the crossbar of your wrecker. Sold individually.
Our price: CA$154.80
Offest 5" Fork Holder Left
Low profile fork holders are just like our 4" with the exception that they fit a 5" x 5" crossbar. They are built using the same cast alloy material that our other quality products are produced from. Sold individually.
Our price: CA$356.00
Offset 5" Fork Holder Right
Low profile fork holders are just like our 4" with the exception that they fit a 5" x 5" crossbar. They are built using the same cast alloy material that our other quality products are produced from. Sold individually.
Our price: CA$356.00
Offset Low Profile Fork Holder Left
These adapters were designed specifically to fit the 4" x 4" crossbar. They have an offset design to offer greater versatility when using your lift forks. They are made from light weight cast alloy and have the standard 2" socket. A pair of grab hooks are welded to the back of the adapter to facilitate safety chains. Sold individually.
Our price: CA$459.00
Your cart
Authentication
Categories
Bestsellers